Techincal Data Sheet
FABRIC
NSF 61 and FDA Compliant
Reinforced Polymer alloy (polyester scrim coated on both sides with PVC polymer)
Total Coated Fabric weight 30 oz sq yard
Low Temperature – 30 F
High Temperature +160
Radio frequency welded seams
FITTINGS
Standard: 1 1/2″ thru 3″
4″ thru 6″ Available Upon Request
Aluminum, Stainless steel, Polypropylene with Camlock, Storz or threaded fittings to accommodate hoses
Ball Valves, Pressure Relief Vents and Caps
OPTIONAL
Ports for Periodic Cleaning and Inspections
Repair Kits
Operational Spare Parts
Minimum Standards for Rainwater Pillow Manufacturing and Installation
Material:
NSF 61 Approved for Potable Water: Regardless of Application
Fittings, Bolt on FPT
Manufacturing:
Radio Frequency Welding
Seam overlap length based on pillow size
All fitting locations re-enforced
Pillow vent centered on top
System Design:
Free Standing Pillow:
All fitting location on pillow must move freely up and down and connected with a length of flexible hose
Overflow/vent/aeration: pipe size on pillow is 2”FPT, additional overflow can be added to in-let plumbing. Can all be installed to center top FPT
Vent must be centered on top
Over flow out-let must be gravity drained and no more than 1’ above full height of pillow
Overflow should not drain into a sump-pump
Overflow water must drain freely without causing water problems
Every rainwater harvesting system must include precautions for water flow in the event of a leak.
Installation:
Pillow Area Preparation:
Remove any sharp objects from floor/sides/overhead
Slope no more than 5” for each 10’ length
Area under pillow should be smooth
Place pillow on tarp or 6 mil. plastic
When moving pillow prevent abrasion, Do Not Drag!
Beware of all sharp objects and tools during installation
Contact Us
Rainwater Collection Solutions, Inc.
The Original Rainwater Pillow
Atlanta, GA
Office: (770) 853-9918
Get More Information!